If the problem persists replace the dispenser. Purge the dispenser with the purge command under diagnostics. Inspect the cassette and feed path for jammed notes. 3.) Refill the cassette and install it in the dispenser To prevent this occurence: 1.) Remove the cassette from the dispenser 2.) Press the RESET ERROR key. If LOW CURRENCY CHECKING is enabled and the terminal dispenses all of its cash and the cassette has not been filled with enough cash to position the packer plate far enough from the dispensers Low Currency reed switch (about 1/2 to 3/4 inch thickness of currency) the terminal will go into Error 182 when the Reset Error button is pressed. If no jam is located remove the first bill from the cassette. Inspect the cassette and feed path for notes that are stuck together or jammed. Ensure there is currency in the cassette. This error is usually associated with an empty cassette or currency that is in UNFIT condition. This is the status after a normal dispense. Received more characters than expected after request causing modem buffer overflow. (If problem persists call Your Service Provider or Triton Tech Support). If EOT is received on subsequent attempts then Error Code 1 is reported. EOT was received as first character after the first request message was sent. No money is dispensed screen and receipt display system unavailable. Communication was normal but response header does not match request.(If problem persists call Your Service Provider or Triton Tech Support) (If problem persists call Your Service Provider or Triton Tech Support) Got connected and never received ENQ within time-out period (14 Seconds). Used up all radial attempt and got Busy Signal for each attempt or No Dial Tone for each attempt. Check local telephone line for proper operation. Used up all radial attempts and got No Dial Tone for each attempt. Baud rate set to high for telephone line conditions. Telephone line may be noisy and in general has poor quality characteristics. (ATM is being used with another devices connected to the line. Possible may be a processor or telephone hardware problem (If problem persists call Your Service Provider or Triton Tech Support)Ĭonnect 1200 Baud then lost carrier or connection. (If problem persists call Your Service Provider or Triton Systems Technical Support) EOT was received as first character after sending a NAK due to a bad response message. At least one character was received (ETX was never received). Time-out waiting for response or carrier was dropped.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |